Step 6. Configure Ridgeline As A Radius Client - Extreme Networks Ridgeline Guide Manual

Step 6. Configure Ridgeline as a RADIUS Client

Once Ridgeline is configured in IAS as a RADIUS client, you must configure it as a RADIUS client
through Ridgeline Administration.
1 In Ridgeline Administration, select the RADIUS tab, as shown in
Figure 295: Configuring Ridgeline as a RADIUS client
2 Click the Enable system as a RADIUS client button.
The Client Configuration section of the page will become available.
3 Enter the host name or IP address of your RADIUS server, and enter the shared secret you used
when you set Ridgeline as a RADIUS client in IAS (see
on page 334).
If you have a secondary RADIUS server, enter that information here also.
4 Click Apply to have this take effect.
Ridgeline Concepts and Solutions Guide
Figure 295.
Step 3. Enable Ridgeline as a RADIUS Client
347