Displaying Vman Configurations - Extreme Networks ExtremeWare XOS Guide Manual

Virtual LANs
configure vman vman_tunnel_1 add port 3:1 untagged
configure vman vman_tunnel_1 add port 3:2 tagged
enable dot1p examination inner-tag port 3:2

Displaying VMAN Configurations

You can display the VMAN configuration and associated EAPS domains by issuing the
command. You can also display VMAN information, as well as all the VLANs, by issuing the
port information detail
To display information on all VMANs, use the following command:
show vman
The following is sample output from the
-------------------------------------------------------------------------------
Name
-------------------------------------------------------------------------------
peggy
t
-------------------------------------------------------------------------------
Flags : (C) EAPS Control vlan, (E) ESRP Enabled, (f) IP Forwarding Enabled,
(i) ISIS Enabled, (I) IP Forwarding lpm-routing Enabled, (L) Loopback
Enabled, (m) IPmc Forwarding Enabled,
(n) IP Multinetting Enabled, (N) Network LogIn vlan,
(o) OSPF Enabled, (p) PIM Enabled,
(P) EAPS protected vlan, (r) RIP Enabled, (T) Member of STP Domain,
(v) VRRP Enabled
Total number of Vlan(s) : 6
To display information on a specific VMAN, use the following command
show vman <vlan_name>
The following is sample output from the
VLAN Interface with name test created by user
Tagging:Untagged (Internal tag 4090)
Priority:
Virtual router: VR-Default
Primary IP
IPv6:
STPD:
Protocol:
Loopback:
NetLogin:
Rate Shape:
QosProfile:
Ports:
Flags:
Untag:
Tag:
238
display.
show vman
VID Protocol Addr
100 10.10.255.3 /24
show vman test
802.1P Priority 0
: 10.10.255.3/24
NONE
None
Match all unfiltered protocols
Disable
Enabled
Disable
QP1
2. (Number of active ports=2)
(*) Active, (!) Disabled
(g) Load Sharing port
*3:1
*3:2
command:
Flags Proto Ports
Active router
/Total
f-----m-------- ANY
command on a modular switch:
ExtremeWare XOS 11.3 Concepts Guide
show vman
show
Virtual
0 /0 VR-Defaul