Ip Dhcp Snooping Limit - Dell PowerEdge M420 Reference Manual

User Guidelines
There are no user guidelines for this command.
Example
console(config)#ip dhcp snooping database write-delay 500

ip dhcp snooping limit

Use the ip dhcp snooping limit command to control the maximum rate of
DHCP messages. Use the no form of this command to reset the limit to the
default.
Syntax
ip dhcp snooping limit {none | rate
no ip dhcp snooping limit
pps —The maximum number of packets per second allowed (Range:
•
0–300 pps).
seconds —The time allowed for a burst (Range: 1–15 seconds).
•
Default Configuration
DHCP snooping rate limiting is disabled.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
There are no user guidelines for this command.
Examples
console(config-if-1/0/1)#ip dhcp snooping limit none
console(config-if-1/0/1)#ip dhcp snooping limit rate
100 burst interval 1
rate
[burst interval
DHCP Snooping Commands
seconds
]}
331