Show Dhcp Lease - Dell PowerEdge M420 Reference Manual

console#debug dhcp packet transmit
The third example is for receive flow.
console#debug dhcp packet receive

show dhcp lease

Use the show dhcp lease command in Privileged EXEC mode to display IPv4
addresses leased from a DHCP server.
Syntax
show dhcp lease [interface
Parameter Description
Parameter
interface-id
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC
User Guidelines
This command lists all IPv4 addresses currently leased from a DHCP server
on a routing interface. This command only applies to routing interfaces. To
see the IPv4 address leased on the out-of-band interface, use the command
"show ip interface out-of-band" on page 1557.
This command output provides the following information.
Term
IP address, Subnet
mask
interface-id
Description
Any valid IP interface (VLAN only). See Interface Naming
Conventions for interface representation.
Description
The IP address and network mask leased from the DHCP server.
DHCP Management Interface Commands
]
321