Virtual Lan Routing Commands - NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual
Managed stackable switch cli manual, software version 9.0
Hide thumbs
Also See for XSM7224S - ProSafe 10 Gigabit Stackable:
- Hardware installation manual (30 pages) ,
- Installation manual (2 pages) ,
- User manual (740 pages)
Table of Contents
Advertisement
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
show ip stats
This command displays IP statistical information. Refer to RFC 1213 for more information about
the fields that are displayed.
Format
show ip stats
Modes
• Privileged EXEC
• User EXEC
Virtual LAN Routing Commands
This section describes the commands you use to view and configure VLAN routing and to view
VLAN routing status information.
vlan routing
This command enables routing on a VLAN. The vlanid value has a range from 1 to 4093. The
[interface ID] value has a range from 1 to 128. Typically, you will not supply the interface ID
argument, and the system automatically selects the interface ID. However, if you specify an
interface ID that is already in use, the CLI displays an error message and does not create the
VLAN interface..
Format
vlan routing <vlanid> [interface ID]
Mode
VLAN Config
no vlan routing
This command deletes routing on a VLAN. The <vlanid> value has a range from 1 to 4093.
Format
no vlan routing <vlanid>
Mode
VLAN Config
Routing Commands
v1.0, November 2010
4-20
Advertisement
Table of Contents
