NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 366
Managed stackable switch cli manual, software version 9.0
Hide thumbs
Also See for XSM7224S - ProSafe 10 Gigabit Stackable:
- Hardware installation manual (30 pages) ,
- Installation manual (2 pages) ,
- User manual (740 pages)
Table of Contents
Advertisement
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no default-router
This command removes the default router list.
Format
no default-router
Mode
DHCP Pool Config
dns-server
This command specifies the IP servers available to a DHCP client. Address parameters are valid IP
addresses; each made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.
Default
none
Format
dns-server <address1> [<address2>....<address8>]
Mode
DHCP Pool Config
no dns-server
This command removes the DNS Server list.
Format
no dns-server
Mode
DHCP Pool Config
hardware-address
This command specifies the hardware address of a DHCP client. Hardware-address is the MAC
address of the hardware platform of the client consisting of 6 bytes in dotted hexadecimal format.
Type indicates the protocol of the hardware platform. It is 1 for 10 MB Ethernet and 6 for IEEE
802.
Default
ethernet
Format
hardware-address <hardwareaddress> <type>
Mode
DHCP Pool Config
Utility Commands
v1.0, November 2010
6-42
Advertisement
Table of Contents
