NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 39

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
• Delete image
• Update bootcode
• Clear config
A reboot operation is allowed during stack firmware synchronization.
If the firmware is corrupted during stack firmware synchronization, manual intervention by the
administrator is required to restore the switch to working condition.
During stack firmware synchronization, traps are generated on start, completion, or failure.
Note:
• Non-deterministic upgrade behavior
On bootup, the image that gets synchronized depends on the one that becomes the manager.
Which code version the new stack synchronizes to is fully deterministic, but might not be
obvious to the user as it depends entirely on which unit becomes the manager. This might be
decided by a MAC address comparison. If the administrator wants a particular version to be
used by the stack, he should first ensure that this particular unit becomes stack manager.
• Bootcode Upgrades
Bootcode upgrades are not initiated by the stack firmware synchronization.
boot auto-copy-sw
This command enables or disables stack firmware synchronization.
Default Disabled
Format
boot auto-copy-sw
Mode Privileged EXEC
no boot auto-copy-sw
This command disables stack firmware synchronization.
Format
no boot auto-copy-sw
Mode Privileged EXEC
Stacking Commands
v1.0, November 2010
2-15