NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 320

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no ipv6 access-list
This command deletes the IPv6 ACL identified by <name> from the system.
Format
no ipv6 access-list <name>
Mode Global Config
ipv6 access-list rename
This command changes the name of an IPv6 ACL. The <name> parameter is the name of an
existing IPv6 ACL. The <newname> parameter is a case-sensitive alphanumeric string from 1 to
31 characters uniquely identifying the IPv6 access list.
This command fails is an IPv6 ACL by the name <newname> already exists.
Format
ipv6 access-list rename <name> <newname>
Mode Global Config
{deny | permit} (IPv6)
This command creates a new rule for the current IPv6 access list. Each rule is appended to the list
of configured rules for the list.
Note: The 'no' form of this command is not supported, since the rules within an IPv6
ACL cannot be deleted individually. Rather, the entire IPv6 ACL must be deleted
and respecified.
Note: An implicit 'deny all' IPv6 rule always terminates the access list.
A rule may either deny or permit traffic according to the specified classification fields. At a
minimum, either the 'every' keyword or the protocol, source address, and destination address
values must be specified. The source and destination IPv6 address fields may be specified using
the keyword 'any' to indicate a match on any value in that field. The remaining command
parameters are all optional, but the most frequently used parameters appear in the same relative
order as shown in the command format.
Quality of Service (QoS) Commands
v1.0, November 2010
5-46