NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 108

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
dot1x guest-vlan
This command configures VLAN as guest vlan on a per port basis. The command specifies an
active VLAN as an IEEE 802.1x guest VLAN. The range is 1 to the maximum VLAN ID
supported by the platform.
Default disabled
Format
dot1x guest-vlan <vlan-id>
Mode Interface Config
no dot1x guest-vlan
This command disables Guest VLAN on the interface.
Default disabled
Format
no dot1x guest-vlan
Mode Interface Config
dot1x initialize
This command begins the initialization sequence on the specified port. This command is only valid
if the control mode for the specified port is "auto" or "mac-based". If the control mode is not 'auto'
or "mac-based", an error will be returned.
Format
dot1x initialize <unit/slot/port>
Mode Privileged EXEC
dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will
transmit an EAPOL EAP Request/Identity frame before timing out the supplicant. The <count>
value must be in the range 1 - 10.
Default 2
Switching Commands
v1.0, November 2010
3-67