Port Configuration Commands - NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
• "LLDP-MED Commands" on page 3-172
• "Denial of Service Commands" on page 3-183
• "MAC Database Commands" on page 3-195
• "ISDP Commands" on page 3-197
• "Priority-Based Flow control commands" on page 3-203
Warning: The commands in this chapter are in one of three functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the
configuration setting.
• Clear commands clear some or all of the settings to factory defaults.

Port Configuration Commands

This section describes the commands you use to view and configure port settings.
interface
This command gives you access to the Interface Config mode, which allows you to enable or
modify the operation of an interface (port).
Format
interface <unit/slot/port>
Mode Global Config
Switching Commands
v1.0, November 2010
3-2