NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 204

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Format
lldp timers [interval <interval-seconds>] [hold <hold-value>] [reinit
<reinit-seconds>
Mode Global Config
no lldp timers
Use this command to return any or all timing parameters for local data transmission on ports
enabled for LLDP to the default values.
Format
no lldp timers [interval] [hold] [reinit]
Mode Global Config
lldp transmit-tlv
Use this command to specify which optional type length values (TLVs) in the 802.1AB basic
management set are transmitted in the LLDPDUs. Use sys-name to transmit the system name
TLV. To configure the system name, see
the system description TLV. Use sys-cap to transmit the system capabilities TLV. Use port-
desc to transmit the port description TLV. To configure the port description, see See
"description" on page 3-5.
Default all optional TLVs are included
Format
lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc]
Mode Interface Config
no lldp transmit-tlv
Use this command to remove an optional TLV from the LLDPDUs. Use the command without
parameters to remove all optional TLVs from the LLDPDU.
Format
no lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc]
Mode Interface Config
Switching Commands
]
"snmp-server" on page
v1.0, November 2010
7-47. Use sys-descto transmit
3-163