Diffserv Service Commands - NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
policy-map
This command establishes a new DiffServ policy. The <policyname> parameter is a case-
sensitive alphanumeric string from 1 to 31 characters uniquely identifying the policy. The type of
policy is specific to the inbound traffic direction as indicated by the in parameter.
Note: The CLI mode is changed to Policy-Map Config when this command is
successfully executed.
Format
policy-map <policyname> in
Mode Global Config
no policy-map
This command eliminates an existing DiffServ policy. The <policyname> parameter is the
name of an existing DiffServ policy. This command may be issued at any time. If the policy is
currently referenced by one or more interface service attachments, this delete attempt fails.
Format
no policy-map <policyname>
Mode Global Config
policy-map rename
This command changes the name of a DiffServ policy. The <policyname> is the name of an
existing DiffServ class. The <newpolicyname> parameter is a case-sensitive alphanumeric
string from 1 to 31 characters uniquely identifying the policy.
Format
policy-map rename <policyname> <newpolicyname>
Mode Global Config

DiffServ Service Commands

Use the DiffServ service commands to assign a DiffServ traffic conditioning policy, which you
specified by using the policy commands, to an interface in the incoming direction
Quality of Service (QoS) Commands
v1.0, November 2010
5-25