NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 317
Managed stackable switch cli manual, software version 9.0
Hide thumbs
Also See for XSM7224S - ProSafe 10 Gigabit Stackable:
- Hardware installation manual (30 pages) ,
- Installation manual (2 pages) ,
- User manual (740 pages)
Table of Contents
Advertisement
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no ip access-group
This command removes a specified IP ACL from an interface.
Default
none
Format
no ip access-group <accesslistnumber> [vlan <vlan-id>] in
Mode
• Interface Config
• Global Config
acl-trapflags
This command enables the ACL trap mode.
Default
disabled
Format
acl-trapflags
Mode
Global Config
no acl-trapflags
This command disables the ACL trap mode.
Format
no acl-trapflags
Mode
Global Config
show ip access-lists
This command displays an IP ACL <accesslistnumber> is the number used to identify the
IP ACL.
Format
show ip access-lists <accesslistnumber>
Mode
Privileged EXEC
Note: Only the access list fields that you configure are displayed.
Quality of Service (QoS) Commands
v1.0, November 2010
5-43
Advertisement
Table of Contents
