ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no lacp partner port priority
Use this command to configure the default LACP partner port priority.
Format
no lacp partner port priority
Mode
Interface Config
lacp partner system id
Use this command to configure the 6-octet MAC Address value representing the administrative
value of the Aggregation Port's protocol Partner's System ID. The valid range of <system-id>
is 00:00:00:00:00:00 - FF:FF:FF:FF:FF.
Default
00:00:00:00:00:00
Format
lacp partner system id <system-id>
Mode
Interface Config
Note: This command is only applicable to physical interfaces.
no lacp partner system id
Use this command to configure the default value representing the administrative value of the
Aggregation Port's protocol Partner's System ID.
Format
no lacp partner system id
Mode
Interface Config
Switching Commands
v1.0, November 2010
3-105