NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 126

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Format
no storm-control broadcast
Mode Global Config
storm-control broadcast level (Global)
This command configures the broadcast storm recovery threshold for all interfaces as a percentage
of link speed and enables broadcast storm recovery. If the mode is enabled, broadcast storm
recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface increases
beyond the configured threshold, the traffic will be dropped. Therefore, the rate of broadcast traffic
will be limited to the configured threshold.This command also enables broadcast storm recovery
mode for all interfaces.
Default 5
Format
storm-control broadcast level <0-100>
Mode Global Config
no storm-control broadcast level
This command sets the broadcast storm recovery threshold to the default value for all interfaces
and disables broadcast storm recovery.
Format
no storm-control broadcast level
Mode Global Config
storm-control broadcast rate (Global)
Use this command to configure the broadcast storm recovery threshold for all interfaces in packets
per second. If the mode is enabled, broadcast storm recovery is active, and if the rate of L2
broadcast traffic ingressing on an interface increases beyond the configured threshold, the traffic is
dropped. Therefore, the rate of broadcast traffic is limited to the configured threshold.
Default 0
Switching Commands
v1.0, November 2010
3-85