NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 500

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Table 8-1: BSP Log Messages
Component Message
BSP Event(0xaaaaaaaa)
BSP Starting code...
Table 8-2: NIM Log Messages
Component Message
NIM NIM: L7_ATTACH out of order for
intIfNum(x) unit x slot x port x
NIM NIM: Failed to find interface at unit x slot x
port x for event(x)
NIM NIM: L7_DETACH out of order for
intIfNum(x) unit x slot x port x
NIM NIM: L7_DELETE out of order for
intIfNum(x) unit x slot x port x
NIM NIM: event(x),intf(x),component(x), in wrong
phase
NIM NIM: Failed to notify users of interface
change
NIM NIM: failed to send message to NIM
message Queue.
NIM NIM: Failed to notify the components of
L7_CREATE event
NIM NIM: Attempted event (x), on USP x.x.x
before phase 3
NIM NIM: incorrect phase for operation
NIM NIM: Component(x) failed on event(x) for
intIfNum(x)
NIM NIM: Timeout event(x), intIfNum(x)
remainingMask = "xxxx"
Log Messages
Cause
Switch has restarted.
BSP initialization complete, starting 7000
series application.
Cause
Interface creation out of order
There is no mapping between the USP and
Interface number
Interface creation out of order
Interface creation out of order
An event was issued to NIM during the
wrong configuration phase (probably Phase
1, 2, or WMU)
Event was not propagated to the system
NIM message queue full or non-existent
Interface not created
A component issued an interface event
during the wrong initialization phase
An API call was made during the wrong
initialization phase
A component responded with a fail
indication for an interface event
A component did not respond before the
NIM timeout occurred
v1.0, November 2010
8-2