NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 203

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no lldp transmit
Use this command to return the local data transmission capability to the default.
Format
no lldp transmit
Mode Interface Config
lldp receive
Use this command to enable the LLDP receive capability.
Default enabled
Format
lldp receive
Mode Interface Config
no lldp receive
Use this command to return the reception of LLDPDUs to the default value.
Format
no lldp receive
Mode Interface Config
lldp timers
Use this command to set the timing parameters for local data transmission on ports enabled for
LLDP. The <interval-seconds> determines the number of seconds to wait between
transmitting local data LLDPDUs. The range is 1-32768 seconds. The <hold-value> is the
multiplier on the transmit interval that sets the TTL in local data LLDPDUs. The multiplier range
is 2-10. The <reinit-seconds> is the delay before re-initialization, and the range is 1-0
seconds.
Default • interval—30 seconds
• hold—4
• reinit—2 seconds
Switching Commands
v1.0, November 2010
3-162