Stacking Commands; Dedicated Port Stacking - NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual

The Stacking Commands chapter includes the following sections:
• "Dedicated Port Stacking" on page 2-1
• "Front Panel Stacking Commands" on page 2-10
• "Non-Stop Forwarding Commands" on page 2-12
• "Stack Firmware Synchronization Commands" on page 2-14
Note: The commands in this chapter are in two functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the
configuration setting.
The Primary Management Unit is the unit that controls the stack.

Dedicated Port Stacking

This section describes the commands you use to configure dedicated port stacking.
stack
This command sets the mode to Stack Global Config.

Stacking Commands

v1.0, November 2010
Chapter 2
2-1