NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 368

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no lease
This command restores the default value of the lease time for DHCP Server.
Format
no lease
Mode DHCP Pool Config
network (DHCP Pool Config)
Use this command to configure the subnet number and mask for a DHCP address pool on the
server. Network-number is a valid IP address, made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid. Mask is the IP subnet mask for the specified address pool. The
prefix-length is an integer from 0 to 32.
Default none
Format
network <networknumber> [{<mask> | <prefixlength>}]
Mode DHCP Pool Config
no network
This command removes the subnet number and mask.
Format
no network
Mode DHCP Pool Config
bootfile
The command specifies the name of the default boot image for a DHCP client. The <filename>
specifies the boot image file.
Format
bootfile <filename>
Mode DHCP Pool Config
Utility Commands
v1.0, November 2010
6-44