NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 355

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
copy
The copy command uploads and downloads files to and from the switch. You can also use the
copy command to manage the dual images (image1 and image2) on the file system. Upload and
download files from a server by using TFTP or Xmodem. SFTP and SCP are available as
additional transfer methods if the software package supports secure management.
Format
copy <source> <destination>
Mode Privileged EXEC
Replace the <source> and <destination> parameters with the options in table below. For
the <url> source or destination, use one of the following values:
{xmodem | tftp://<ipaddr|hostname>|<ip6address|hostname>/<filepath>/<filename>
[noval]
| sftp|scp://<username>@<ipaddr>|<ipv6address>|<filepath>|<filename>}
For TFTP, SFTP and SCP, the <ipaddr|hostname> parameter is the IP address or host name
of the server, <filepath> is the path to the file, and <filename> is the name of the file you
want to upload or download. For SFTP and SCP, the <username> parameter is the username for
logging into the remote server via SSH.
Note: <ip6address> is also a valid parameter for routing packages that support IPv6.
For platforms that support a USB device, the
from and to the USB device. The syntax for the USB file is:
USB device can be either a source or destination in the copy command. It cannot be used
as both source and destination in a given
Warning: Remember to upload the existing Switch CLI.cfg file off the switch prior to
loading a new release image in order to make a backup.
Parameters for the
copy
Source
nvram:backup-config
nvram:clibanner
Utility Commands
copy
command are listed in the following table:
Destination
nvram:startup-config
<url>
v1.0, November 2010
command can be used to transfer files
copy
usb://<filename>
command.
Description
Copies the backup configuration to the startup
configuration.
Copies the CLI banner to a server.
. The
6-31