NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 18
Managed stackable switch cli manual, software version 9.0
Hide thumbs
Also See for XSM7224S - ProSafe 10 Gigabit Stackable:
- Hardware installation manual (30 pages) ,
- Installation manual (2 pages) ,
- User manual (740 pages)
Table of Contents
Advertisement
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Table 5. CLI Command Modes
Command Mode
Prompt
User EXEC
Switch>
Privileged EXEC
Switch#
Global Config
Switch (Config)#
VLAN Config
Switch (Vlan)#
Interface Config
Switch (Interface <unit/slot/port>)#
Switch (Interface Loopback <id>)#
Switch (Interface Tunnel <id>)#
Line Config
Switch (line)#
Policy Map
Switch (Config-policy-map)#
Config
Policy Class
Switch (Config-policy-class-map)#
Config
Class Map Config
Switch (Config-class-map)#
Ipv6_Class-Map
Switch (Config-class-map)#
Config
Router OSPF
Switch (Config-router)#
Config
Router OSPFv3
Switch (Config rtr)#
Config
Router RIP Config Switch (Config-router)#
Router BGP
Switch (Config-router)#
Config
MAC Access-list
Switch (Config-mac-access-list)#
Config
Using the Command-Line Interface
Mode Description
Contains a limited set of commands to view
basic system information.
Allows you to issue any EXEC command, enter
the VLAN mode, or enter the Global
Configuration mode.
Groups general setup commands and permits
you to make modifications to the running
configuration.
Groups all the VLAN commands.
Manages the operation of an interface and
provides access to the router interface
configuration commands.
Use this mode to set up a physical port for a
specific logical connection operation.
Contains commands to configure outbound
telnet settings and console interface settings.
Contains the QoS Policy-Map configuration
commands.
Consists of class creation, deletion, and
matching commands. The class match
commands specify Layer 2, Layer 3, and
general match criteria.
Contains the QoS class map configuration
commands for IPv4.
Contains the QoS class map configuration
commands for IPv6.
Contains the OSPF configuration commands.
Contains the OSPFv3 configuration commands.
Contains the RIP configuration commands.
Contains the BGP4 configuration commands.
Allows you to create a MAC Access-List and to
enter the mode containing MAC Access-List
configuration commands.
v1.0, November 2010
1-6
Advertisement
Table of Contents
