NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 177
Managed stackable switch cli manual, software version 9.0
Hide thumbs
Also See for XSM7224S - ProSafe 10 Gigabit Stackable:
- Hardware installation manual (30 pages) ,
- Installation manual (2 pages) ,
- User manual (740 pages)
Table of Contents
Advertisement
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Format
no ip arp inspection vlan vlan-list logging
Mode
Global Config
ip arp inspection trust
Use this command to configure an interface as trusted for Dynamic ARP Inspection.
Default
enabled
Format
ip arp inspection trust
Mode
Interface Config
no ip arp inspection trust
Use this command to configure an interface as untrusted for Dynamic ARP Inspection.
Format
no ip arp inspection trust
Mode
Interface Config
ip arp inspection limit
Use this command to configure the rate limit and burst interval values for an interface.
Configuring none for the limit means the interface is not rate limited for Dynamic ARP
Inspections.
Note: The user interface will accept a rate limit for a trusted interface, but the limit will
not be enforced unless the interface is configured to be untrusted.
Default
15 pps for rate and 1 second for burst-interval
Format
ip arp inspection limit {rate pps [burst interval seconds] | none}
Mode
Interface Config
Switching Commands
v1.0, November 2010
3-136
Advertisement
Table of Contents
