NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 55

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using. The Configuration Identifier Revision Level is a
number in the range of 0 to 65535.
Default 0
Format
spanning-tree configuration revision <0-65535>
Mode Global Config
no spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using to the default value.
Format
no spanning-tree configuration revision
Mode Global Config
spanning-tree edgeport
This command specifies that this port is an Edge Port within the common and internal spanning
tree. This allows this port to transition to Forwarding State without delay.
Default
enabled
Format
spanning-tree edgeport
Mode Interface Config
no spanning-tree edgeport
This command specifies that this port is not an Edge Port within the common and internal
spanning tree.
Format
no spanning-tree edgeport
Mode Interface Config
Switching Commands
v1.0, November 2010
3-14