NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 29

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
set slot disable
This command configures the administrative mode of the slot(s). If you specify [all], the
command is applied to all slots, otherwise the command is applied to the slot identified by
<unit/slot>.
If a card or other module is present in the slot, this administrative mode will effectively be applied
to the contents of the slot. If the slot is empty, this administrative mode will be applied to any
module that is inserted into the slot. If a card is disabled, all the ports on the device are
operationally disabled and shown as "unplugged" on management screens.
Format
set slot disable [<unit/slot> | all]
Mode Global Config
no set slot disable
This command unconfigures the administrative mode of the slot(s). If you specify [all], the
command removes the configuration from all slots, otherwise the configuration is removed from
the slot identified by <unit/slot>.
If a card or other module is present in the slot, this administrative mode removes the configuration
from the contents of the slot. If the slot is empty, this administrative mode removes the
configuration from any module inserted into the slot. If a card is disabled, all the ports on the
device are operationally disabled and shown as "unplugged" on management screens.
Format
no set slot disable [<unit/slot> | all]
Mode Global Config
set slot power
This command configures the power mode of the slot(s) and allows power to be supplied to a card
located in the slot. If you specify [all], the command is applied to all slots, otherwise the
command is applied to the slot identified by <unit/slot>.
Stacking Commands
v1.0, November 2010
2-5