NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 79
Managed stackable switch cli manual, software version 9.0
Hide thumbs
Also See for XSM7224S - ProSafe 10 Gigabit Stackable:
- Hardware installation manual (30 pages) ,
- Installation manual (2 pages) ,
- User manual (740 pages)
Table of Contents
Advertisement
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no vlan port pvid all
This command sets the VLAN ID for all interfaces to 1.
Format
no vlan port pvid all
Mode
Global Config
vlan port tagging all
This command configures the tagging behavior for all interfaces in a VLAN to enabled. If tagging
is enabled, traffic is transmitted as tagged frames. If tagging is disabled, traffic is transmitted as
untagged frames. The ID is a valid VLAN identification number.
Format
vlan port tagging all <1-4093>
Mode
Global Config
no vlan port tagging all
This command configures the tagging behavior for all interfaces in a VLAN to disabled. If tagging
is disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN identification
number.
Format
no vlan port tagging all
Mode
Global Config
vlan protocol group
This command adds protocol-based VLAN groups to the system. When it is created, the protocol
group will be assigned a unique number (1-128) that will be used to identify the group in
subsequent commands.
Format
vlan protocol group <1-128>
Mode
Global Config
Switching Commands
v1.0, November 2010
3-38
Advertisement
Table of Contents
