NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 100

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Default 20
Format
set garp timer join <10-100>
Mode • Interface Config
• Global Config
no set garp timer join
This command sets the GVRP join time (for one or all ports and per GARP) to the default and only
has an effect when GVRP is enabled.
Format
no set garp timer join
Mode • Interface Config
• Global Config
set garp timer leave
This command sets the GVRP leave time for one port (Interface Config mode) or all ports (Global
Config mode) and only has an effect when GVRP is enabled. Leave time is the time to wait after
receiving an unregister request for a VLAN or a multicast group before deleting the VLAN entry.
This can be considered a buffer time for another station to assert registration for the same attribute
in order to maintain uninterrupted service. The leave time is 20 to 600 (centiseconds). The value
60 centiseconds is 0.6 seconds.
Default 60
Format
set garp timer leave <20-600>
Mode • Interface Config
• Global Config
no set garp timer leave
This command sets the GVRP leave time on all ports or a single port to the default and only has an
effect when GVRP is enabled.
Switching Commands
v1.0, November 2010
3-59