NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 397

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Format
no debug ipv6 pimsm packet [receive|transmit]
Mode Privileged EXEC
debug lacp packet
This command enables tracing of LACP packets received and transmitted by the switch.
Default disabled
Format
debug lacp packet
Mode Privileged EXEC
A sample output of the trace message is shown below.
<15> JAN 01 14:04:51 10.254.24.31-1 DOT3AD[183697744]: dot3ad_debug.c(385) 58 %%
Pkt TX - Intf: 1/0/1(1), Type: LACP, Sys: 00:11:88:14:62:e1, State: 0x47, Key:
0x36
no debug lacp packet
This command disables tracing of LACP packets.
Format
no debug lacp packet
Mode Privileged EXEC
debug mldsnooping packet
Use this command to trace MLD snooping packet reception and transmission. receive traces only
received MLD snooping packets and transmit traces only transmitted MLD snooping packets.
When neither keyword is used in the command, then all MLD snooping packet traces are dumped.
Vital information such as source address, destination address, control packet type, packet length,
and the interface on which the packet is received or transmitted is displayed on the console.
Default disabled
Format
debug mldsnooping packet [receive|transmit]
Mode Privileged EXEC
Utility Commands
v1.0, November 2010
6-73