NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 147

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
lacp partner system priority
Use this command to configure the administrative value of the priority associated with the
Partner's System ID. The valid range for <priority> is 0 to 65535.
Default 0x0
Format
lacp partner system priority <priority>
Mode Interface Config
Note: This command is only applicable to physical interfaces.
no lacp partner system priority
Use this command to configure the default administrative value of priority associated with the
Partner's System ID.
Format
no lacp partner system priority
Mode Interface Config
port-channel static
This command enables the static mode on a port-channel (LAG) interface. By default the static
mode for a new port-channel is disabled, which means the port-channel is dynamic. However if the
maximum number of allowable dynamic port-channels are already present in the system, the static
mode for a new port-channel enabled, which means the port-channel is static.You can only use this
command on port-channel interfaces.
Default disabled
Format
port-channel static
Mode Interface Config
Switching Commands
v1.0, November 2010
3-106