NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 115

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
dot1x dynamic-vlan enable
Use this command to enable the switch to create VLANs dynamically when a RADIUS assigned
VLAN does not exist in the switch.
Format
dot1x dynamic-vlan enable
Mode Global Config
Default Disabled
no dot1x dynamic-vlan enable
Use this command to disable the switch from creating VLANs dynamically when a RADIUS
assigned VLAN does not exist in the switch.
Format
no dot1x dynamic-vlan enable
Mode Global Config
dot1x system-auth-control monitor
Use this command to enable the 802.1X monitor mode on the switch. The purpose of Monitor
mode is to help troubleshoot port-based authentication configuration issues without disrupting
network access for hosts connected to the switch. In Monitor mode, a host is granted network
access to an 802.1X-enabled port even if it fails the authentication process. The results of the
process are logged for diagnostic purposes.
Format
dot1x system-auth-control monitor
Mode Global Config
Default Disabled
no dot1x system-auth-control monitor
Use this command to disable the 802.1X monitor on the switch.
Format
no dot1x system-auth-control monitor
Mode Global Config
Switching Commands
v1.0, November 2010
3-74