NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 178
Managed stackable switch cli manual, software version 9.0
Hide thumbs
Also See for XSM7224S - ProSafe 10 Gigabit Stackable:
- Hardware installation manual (30 pages) ,
- Installation manual (2 pages) ,
- User manual (740 pages)
Table of Contents
Advertisement
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no ip arp inspection limit
Use this command to set the rate limit and burst interval values for an interface to the default
values of 15 pps and 1 second, respectively.
Format
no ip arp inspection limit
Mode
Interface Config
ip arp inspection filter
Use this command to configure the ARP ACL used to filter invalid ARP packets on a list of
comma-separated VLAN ranges. If the static keyword is given, packets that do not match a permit
statement are dropped without consulting the DHCP snooping bindings.
Default
No ARP ACL is configured on a VLAN
Format
ip arp inspection filter acl-name vlan vlan-list [static]
Mode
Global Config
no ip arp inspection filter
Use this command to unconfigure the ARP ACL used to filter invalid ARP packets on a list of
comma-separated VLAN ranges.
Format
no ip arp inspection filter acl-name vlan vlan-list [static]
Mode
Global Config
arp access-list
Use this command to create an ARP ACL.
Format
arp access-list acl-name
Mode
Global Config
Switching Commands
v1.0, November 2010
3-137
Advertisement
Table of Contents
