NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 372

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Format
ip dhcp excluded-address <lowaddress> [highaddress]
Mode Global Config
no ip dhcp excluded-address
This command removes the excluded IP addresses for a DHCP client. Low-address and high-
address are valid IP addresses; each made up of four decimal bytes ranging from 0 to 255. IP
address 0.0.0.0 is invalid.
Format
no ip dhcp excluded-address <lowaddress> [highaddress]
Mode Global Config
ip dhcp ping packets
Use this command to specify the number, in a range from 2-10, of packets a DHCP server sends to
a pool address as part of a ping operation. By default the number of packets sent to a pool address
is 2, which is the smallest allowed number when sending packets. Setting the number of packets to
0 disables this command.
Default 2
Format
ip dhcp ping packets <0,2-10>
Mode Global Config
no ip dhcp ping packets
This command prevents the server from pinging pool addresses and sets the number of packets to
0.
Default 0
Format
no ip dhcp ping packets
Mode Global Config
Utility Commands
v1.0, November 2010
6-48