ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Default
vman
Format
dvlan-tunnel ethertype {802.1Q | vman | custom} [0-65535]
Mode
Global Config
mode dot1q-tunnel
This command is used to enable Double VLAN Tunneling on the specified interface.
Default
disabled
Format
mode dot1q-tunnel
Mode
Interface Config
no mode dot1q-tunnel
This command is used to disable Double VLAN Tunneling on the specified interface. By default,
Double VLAN Tunneling is disabled.
Format
no mode dot1q-tunnel
Mode
Interface Config
mode dvlan-tunnel
Use this command to enable Double VLAN Tunneling on the specified interface.
Note: When you use the mode dvlan-tunnel command on an interface, it becomes
a service provider port. Ports that do not have double VLAN tunneling enabled are
customer ports.
Default
disabled
Format
mode dvlan-tunnel
Mode
Interface Config
Switching Commands
v1.0, November 2010
3-48