NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 422

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no network mac-type
This command resets the value of MAC address to its default.
Format
no network mac-type
Mode Privileged EXEC
network javamode
This command specifies whether or not the switch should allow access to the Java applet in the
header frame of the Web interface. When access is enabled, the Java applet can be viewed from the
Web interface. When access is disabled, the user cannot view the Java applet.
Default enabled
Format
network javamode
Mode Privileged EXEC
no network javamode
This command disallows access to the Java applet in the header frame of the Web interface. When
access is disabled, the user cannot view the Java applet.
Format
no network javamode
Mode Privileged EXEC
show network
This command displays configuration settings associated with the switch's network interface. The
network interface is the logical interface used for in-band connectivity with the switch via any of
the switch's front panel ports. The configuration parameters associated with the switch's network
interface do not affect the configuration of the front panel ports through which traffic is switched
or routed. The network interface is always considered to be up, whether or not any member ports
are up; therefore, the show network command will always show "Interface Status" as "Up".
Format
show network
Modes • Privileged EXEC
• User EXEC
Management Commands
v1.0, November 2010
7-6