NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 46
Managed stackable switch cli manual, software version 9.0
Hide thumbs
Also See for XSM7224S - ProSafe 10 Gigabit Stackable:
- Hardware installation manual (30 pages) ,
- Installation manual (2 pages) ,
- User manual (740 pages)
Table of Contents
Advertisement
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
description
Use this command to create an alpha-numeric description of the port.
Format
description <description>
Mode
Interface Config
mtu
Use the mtu command to set the maximum transmission unit (MTU) size, in bytes, for frames that
ingress or egress the interface. You can use the mtu command to configure jumbo frame support
for physical and port-channel (LAG) interfaces. For the standard 7000 series implementation, the
MTU size is a valid integer between 1522 - 9216 for tagged packets and a valid integer between
1518 - 9216 for untagged packets.
Note: To receive and process packets, the Ethernet MTU must include any extra bytes
that Layer-2 headers might require. To configure the IP MTU size, which is the
maximum size of the IP packet (IP Header + IP payload), see
12.
Default
1518 (untagged)
Format
mtu <1518-9216>
Mode
Interface Config
no mtu
This command sets the default MTU size (in bytes) for the interface.
Format
no mtu
Mode
Interface Config
Switching Commands
v1.0, November 2010
"ip mtu" on page 4-
3-5
Advertisement
Table of Contents
