NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 349

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Example: The following are examples of the CLI command.
traceroute Success:
(Switch) # traceroute 10.240.10.115 initTtl 1 maxTtl 4 maxFail 0 interval 1 count
3 port 33434 size 43
Traceroute to 10.240.10.115 ,4 hops max 43 byte packets:
1 10.240.4.1 708 msec
2 10.240.10.115
Hop Count = 1 Last TTL = 2 Test attempt = 6 Test Success = 6
traceroute Failure:
(Switch) # traceroute 10.40.1.1 initTtl 1 maxFail 0 interval 1 count 3
port 33434 size 43
Traceroute to 10.40.1.1 ,30 hops max 43 byte packets:
1 10.240.4.1 19 msec
2 10.240.1.252 0 msec
3 172.31.0.9 277 msec
4 10.254.1.1 289 msec
5 10.254.21.2 287 msec
6 192.168.76.2 290 msec
7 0.0.0.0 0 msec *
Hop Count = 6 Last TTL = 7 Test attempt = 19 Test Success = 18
traceroute ipv6
Use the traceroute command to discover the routes that packets actually take when traveling
to their destination through the network on a hop-by-hop basis. The <ipv6-
address|hostname> parameter must be a valid IPv6 address or hostname. The optional
<port> parameter is the UDP port used as the destination of packets sent as part of the
traceroute. This port should be an unused port on the destination system. The range for <port>
is zero (0) to 65535. The default value is 33434.
Default port: 33434
Format
traceroute ipv6 <ipv6-address|hostname> [port <port>]
Mode Privileged EXEC
Utility Commands
41 msec
0 msec 0 msec
18 msec
0 msec
276 msec
327 msec
293 msec
291 msec
v1.0, November 2010
11 msec
0 msec
9 msec
1 msec
277 msec
282 msec
296 msec
289 msec
6-25