NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 430

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no session-timeout
This command sets the Telnet session timeout value to the default. The timeout value unit of time
is minutes.
Format
no session-timeout
Mode Line Config
telnetcon maxsessions
This command specifies the maximum number of Telnet connection sessions that can be
established. A value of 0 indicates that no Telnet connection can be established. The range is 0-5.
Default 4
Format
telnetcon maxsessions <0-4>
Mode Privileged EXEC
no telnetcon maxsessions
This command sets the maximum number of Telnet connection sessions that can be established to
the default value.
Format
no telnetcon maxsessions
Mode Privileged EXEC
telnetcon timeout
This command sets the Telnet connection session timeout value, in minutes. A session is active as
long as the session has not been idle for the value set. The time is a decimal value from 1 to 160.
Note: When you change the timeout value, the new value is applied to all active and
inactive sessions immediately. Any sessions that have been idle longer than the
new timeout value are disconnected immediately.
Default 5
Format
telnetcon timeout <1-160>
Mode Privileged EXEC
Management Commands
v1.0, November 2010
7-14