NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 525

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Table 8-53: OSAPI Log Messages (continued)
Component Message
OSAPI osapiCleanupIf: NetIPGet
OSAPI osapiCleanupIf: NetMaskGet
OSAPI osapiCleanupIf: NetIpDel
OSAPI osapiSemaTake failed
Log Messages
Cause
During the call to remove the interface from
the route table, the attempt to get an ipv4
interface address from the stack failed.
During the call to remove the interface from
the route table ,the attempt to get the ipv4
interface mask from the stack failed.
During the call to remove the interface from
the route table, the attempt to delete the
primary ipv4 address from the stack failed.
The requested semaphore can not be taken
because: the call is made from an ISR or the
semaphore ID is invalid.
v1.0, November 2010
8-27