NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 477
Managed stackable switch cli manual, software version 9.0
Hide thumbs
Also See for XSM7224S - ProSafe 10 Gigabit Stackable:
- Hardware installation manual (30 pages) ,
- Installation manual (2 pages) ,
- User manual (740 pages)
Table of Contents
Advertisement
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
the authenticating and accounting servers are configured without a name, the command uses the
'Default_RADIUS_Auth_Server' and 'Default_RADIUS_Acct_Server' as the default names,
respectively. The same name can be configured for more than one authenticating servers and the
name should be unique for accounting servers. The RADIUS client allows the configuration of a
maximum 32 authenticating and accounting servers.
If you use the <auth> parameter, the command configures the IP address or hostname to use to
connect to a RADIUS authentication server. You can configure up to 3 servers per RADIUS client.
If the maximum number of configured servers is reached, the command fails until you remove one
of the servers by issuing the "no" form of the command. If you use the optional <port>
parameter, the command configures the UDP port number to use when connecting to the
configured RADIUS server. The <port> number range is 1 - 65535, with 1812 being the default
value.
Note: To re-configure a RADIUS authentication server to use the default UDP <port>,
set the <port> parameter to 1812.
If you use the <acct> token, the command configures the IP address or hostname to use for the
RADIUS accounting server. You can only configure one accounting server. If an accounting server
is currently configured, use the "no" form of the command to remove it from the configuration.
The IP address or hostname you specify must match that of a previously configured accounting
server. If you use the optional <port> parameter, the command configures the UDP port to use
when connecting to the RADIUS accounting server. If a <port> is already configured for the
accounting server, the new <port> replaces the previously configured <port>. The <port>
must be a value in the range 0 - 65535, with 1813 being the default.
Note: To re-configure a RADIUS accounting server to use the default UDP <port>, set
the <port> parameter to 1813.
Format
radius server host {auth | acct} {<ipaddr|dnsname>} [name
<servername>] [port <0-65535>][server-type]
Mode
Global Config
Field
Description
ipaddr
The IP address of the server.
Management Commands
v1.0, November 2010
7-61
Advertisement
Table of Contents
