Ip Address Conflict Commands - NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0

IP Address Conflict Commands

ip address-conflict-detect run
This command triggers the switch to run active address conflict detection by sending gratuitous
ARP packets for IPv4 addresses on the switch.
Format
ip address-conflict-detect run
Mode Global Config
show ip address-conflict
This command displays the status information corresponding to the last detected address conflict.
Term Definition
Address Conflict Identifies whether the switch has detected an address conflict on any IP address.
Detection Status
Last Conflicting The IP Address that was last detected as conflicting on any interface.
IP Address
Last Conflicting The MAC Address of the conflicting host that was last detected on any interface.
MAC Address
Time Since The time in days, hours, minutes and seconds since the last address conflict was
Conflict
detected.
Detected
clear ip address-conflict-detect
This command clears the detected address conflict status information.
Format
clear ip address-conflict-detect
Mode Privileged EXEC
Utility Commands
v1.0, November 2010
6-90