Igmp Snooping Configuration Commands - NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Format
show arp access-list [acl-name]
Mode • Privileged EXEC
• User EXEC
Example: The following shows example CLI display output for the command.
(Switch) #show arp access-list
ARP access list H2
permit ip host 1.1.1.1 mac host 00:01:02:03:04:05
permit ip host 1.1.1.2 mac host 00:03:04:05:06:07
ARP access list H3
ARP access list H4
permit ip host 2.1.1.2 mac host 00:03:04:05:06:08

IGMP Snooping Configuration Commands

This section describes the commands you use to configure IGMP snooping. The software supports
IGMP Versions 1, 2, and 3. The IGMP snooping feature can help conserve bandwidth because it
allows the switch to forward IP multicast traffic only to connected hosts that request multicast
traffic. IGMPv3 adds source filtering capabilities to IGMP versions 1 and 2.
set igmp
This command enables IGMP Snooping on the system (Global Config Mode) or an interface
(Interface Config Mode). This command also enables IGMP snooping on a particular VLAN
(VLAN Config Mode) and can enable IGMP snooping on all interfaces participating in a VLAN.
If an interface has IGMP Snooping enabled and you enable this interface for routing or enlist it as
a member of a port-channel (LAG), IGMP Snooping functionality is disabled on that interface.
IGMP Snooping functionality is re-enabled if you disable routing or remove port-channel (LAG)
membership from an interface that has IGMP Snooping enabled.
The IGMP application supports the following activities:
• Validation of the IP header checksum (as well as the IGMP header checksum) and discarding
of the frame upon checksum error.
• Maintenance of the forwarding table entries based on the MAC address versus the IP address.
Switching Commands
v1.0, November 2010
3-142