Show Trapflags - NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual
Managed stackable switch cli manual, software version 9.0
Hide thumbs
Also See for XSM7224S - ProSafe 10 Gigabit Stackable:
- Hardware installation manual (30 pages) ,
- Installation manual (2 pages) ,
- User manual (740 pages)
Table of Contents
Advertisement
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
show trapflags
This command displays trap conditions. The command's display shows all the enabled OSPFv2
and OSPFv3 trapflags. Configure which traps the switch should generate by enabling or disabling
the trap condition. If a trap condition is enabled and the condition is detected, the SNMP agent on
the switch sends the trap to all enabled trap receivers. You do not have to reset the switch to
implement the changes. Cold and warm start traps are always generated and cannot be disabled.
Format
show trapflags
Mode
Privileged EXEC
Term
Definition
Authentication
Can be enabled or disabled. The factory default is enabled. Indicates whether
Flag
authentication failure traps will be sent.
Link Up/Down
Can be enabled or disabled. The factory default is enabled. Indicates whether link status
Flag
traps will be sent.
Multiple Users
Can be enabled or disabled. The factory default is enabled. Indicates whether a trap will
Flag
be sent when the same user ID is logged into the switch more than once at the same time
(either through Telnet or the serial port).
Spanning Tree
Can be enabled or disabled. The factory default is enabled. Indicates whether spanning
Flag
tree traps are sent.
ACL Traps
May be enabled or disabled. The factory default is disabled. Indicates whether ACL traps
are sent.
DVMRP Traps
Can be enabled or disabled. The factory default is disabled. Indicates whether DVMRP
traps are sent.
OSPFv2 Traps
Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF
traps are sent. If any of the OSPF trap flags are not enabled, then the command displays
disabled. Otherwise, the command shows all the enabled OSPF traps' information.
OSPFv3 Traps
Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF
traps are sent. If any of the OSPFv3 trap flags are not enabled, then the command
displays disabled. Otherwise, the command shows all the enabled OSPFv3 traps'
information.
PIM Traps
Can be enabled or disabled. The factory default is disabled. Indicates whether PIM traps
are sent.
Management Commands
v1.0, November 2010
7-58
Advertisement
Table of Contents
