NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 447

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
username snmpv3 accessmode
This command specifies the snmpv3 access privileges for the specified login user. The valid
accessmode values are readonly or readwrite. The <username> is the login user name
for which the specified access mode applies. The default is readwrite for the "admin" user and
readonly for all other users. You must enter the <username> in the same case you used when
you added the user. To see the case of the <username>, enter the show users command.
Defaults • admin - readwrite
• other - readonly
Format
username snmpv3 accessmode <username> {readonly | readwrite}
Mode Global Config
no username snmpv3 accessmode
This command sets the snmpv3 access privileges for the specified user as readwrite for the
"admin" user and readonly for all other users. The <username> value is the user name for
which the specified access mode will apply.
Format
no username snmpv3 accessmode <username>
Mode Global Config
username snmpv3 authentication
This command specifies the authentication protocol to be used for the specified user. The valid
authentication protocols are none, md5 or sha. If you specify md5 or sha, the login password is
also used as the snmpv3 authentication password and therefore must be at least eight characters in
length. The <username> is the user name associated with the authentication protocol. You must
enter the <username> in the same case you used when you added the user. To see the case of the
<username>, enter the show users command.
Default no authentication
Format
username snmpv3 authentication <username> {none | md5 | sha}
Mode Global Config
Management Commands
v1.0, November 2010
7-31