NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 109

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Format
dot1x max-req <count>
Mode Interface Config
no dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will
transmit an EAPOL EAP Request/Identity frame before timing out the supplicant.
Format
no dot1x max-req
Mode Interface Config
dot1x max-users
Use this command to set the maximum number of clients supported on the port when MAC-based
dot1x authentication is enabled on the port. The maximum users supported per port is dependent
on the product. The <count> value is in the range 1 - 16.
Default 16
Format
dot1x max-users <count>
Mode Interface Config
no dot1x max-users
This command resets the maximum number of clients allowed per port to its default value.
Format
no dot1x max-req
Mode Interface Config
dot1x port-control
This command sets the authentication mode to use on the specified port. Select force-
unauthorized to specify that the authenticator PAE unconditionally sets the controlled port to
unauthorized. Select force-authorized to specify that the authenticator PAE unconditionally
sets the controlled port to authorized. Select auto to specify that the authenticator PAE sets the
Switching Commands
v1.0, November 2010
3-68