NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 81

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no vlan protocol group add protocol
This command removes the <protocol> from this protocol-based VLAN group that is
identified by this <groupid>. The possible values for protocol are ip, arp, and ipx.
Format
no vlan protocol group add protocol <groupid> ethertype {<protocol-
list>|arp|ip|ipx}
Mode Global Config
protocol group
This command attaches a <vlanid> to the protocol-based VLAN identified by <groupid>.
A group may only be associated with one VLAN at a time, however the VLAN association can be
changed.
Default none
Format
protocol group <groupid> <vlanid>
Mode VLAN Config
no protocol group
This command removes the <vlanid> from this protocol-based VLAN group that is identified
by this <groupid>.
Format
no protocol group <groupid> <vlanid>
Mode VLAN Config
protocol vlan group
This command adds the physical interface to the protocol-based VLAN identified by
<groupid>. You can associate multiple interfaces with a group, but you can only associate each
interface and protocol combination with one group. If adding an interface to a group causes any
conflicts with protocols currently associated with the group, this command fails and the
interface(s) are not added to the group.
Switching Commands
v1.0, November 2010
3-40