NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 510

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Table 8-21: Mac-based VLANs Log Messages
Component Message
Mac based vlanMacVlanChangeCallback: Failed to
VLANS
delete an entry
Table 8-22: 802.1x Log Messages
Component Message
802.1X function: Failed calling dot1xIssueCmd
802.1X function: EAP message not received from
server
802.1X function: Out of System buffers
802.1X function: could not set state to <authorized/
unauthorized>, intf xxx
802.1X dot1xApplyConfigData: Unable to <enable/
disable> dot1x in driver
802.1X dot1xSendRespToServer:
dot1xRadiusAccessRequestSend failed
802.1X dot1xRadiusAcceptProcess: error calling
radiusAccountingStart, ifIndex=xxx
802.1X function: failed sending terminate cause, intf
xxx
Table 8-23: IGMP Snooping Log Messages
Component Message
IGMP Snooping function: osapiMessageSend failed
IGMP Snooping Failed to set global igmp snooping mode to
xxx
IGMP Snooping Failed to set igmp snooping mode xxx for
interface yyy
IGMP Snooping Failed to set igmp mrouter mode xxx for
interface yyy
IGMP Snooping Failed to set igmp snooping mode xxx for
vlan yyy
Log Messages
Cause
This appears when a dtl fails to delete an
entry for an vlan delete notify event.
Cause
802.1X message queue is full
RADIUS server did not send required EAP
message
802.1X cannot process/transmit message
due to lack of internal buffers
DTL call failed setting authorization state of
the port
DTL call failed enabling/disabling 802.1X
Failed sending message to RADIUS server
Failed sending accounting start to RADIUS
server
Failed sending accounting stop to RADIUS
server
Cause
IGMP Snooping message queue is full
Failed to set global IGMP Snooping mode
due to message queue being full
Failed to set interface IGMP Snooping mode
due to message queue being full
Failed to set interface multicast router mode
due to IGMP Snooping message queue
being full
Failed to set VLAN IGM Snooping mode due
to message queue being full
v1.0, November 2010
8-12