NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 148

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no port-channel static
This command sets the static mode on a particular port-channel (LAG) interface to the default
value. This command will be executed only for interfaces of type port-channel (LAG).
Format
no port-channel static
Mode Interface Config
port lacpmode
This command enables Link Aggregation Control Protocol (LACP) on a port.
Default enabled
Format
port lacpmode
Mode Interface Config
no port lacpmode
This command disables Link Aggregation Control Protocol (LACP) on a port.
Format
no port lacpmode
Mode Interface Config
port lacpmode enable all
This command enables Link Aggregation Control Protocol (LACP) on all ports.
Format
port lacpmode enable all
Mode Global Config
Switching Commands
v1.0, November 2010
3-107