Private Group Commands - NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Term Definition
Name A string associated with this group as a convenience. It can be up to 32 alphanumeric
characters long, including blanks. The default is blank. This field is optional.
Protected port Indicates whether the interface is protected or not. It shows TRUE or FALSE. If the group
is a multiple groups then it shows TRUE in Group <groupid>.

Private Group Commands

This section describes commands used to configure private group and view private group
configuration information.
Private group can be used to create a group of ports that can or can not share traffic to each others
in the same VLAN group. The main application is to isolate a group of users from another without
using VLAN.
switchport private-group
This command is used to assign one port or a range of ports to private group <privategroup-name>
(or <private-group-id>).
The ingress traffic from a port in private group can be forwarded to other ports either in the same
private group or anyone in the same VLAN that are not in a private group.
By default, a port does not belong to any private group. A port cannot be in more than one private
group. An error message should return when that occurred. To change a port's private group, first
the port must be removed from its private group.
Default port not associated with any group.
Format
switchport private-group [<privategroup-name>|<privategroup-id>]
Mode Interface Config
Switching Commands
v1.0, November 2010
3-56