NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 480

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no radius server msgauth
The version of this command disables the message authenticator attribute to be used for the
no
specified RADIUS Authenticating server.
Format
no radius server msgauth <ipaddr|dnsname>
Mode Global Config
radius server primary
This command specifies a configured server that should be the primary server in the group of
servers which have the same server name. Multiple primary servers can be configured for each
number of servers that have the same name. When the RADIUS client has to perform transactions
with an authenticating RADIUS server of specified name, the client uses the primary server that
has the specified server name by default. If the RADIUS client fails to communicate with the
primary server for any reason, the client uses the backup servers configured with the same server
name. These backup servers are identified as the 'Secondary' type.
Format
radius server primary {<ipaddr|dnsname>}
Mode Global Config
Field Description
ip addr The IP address of the RADIUS Authenticating server.
dnsname The DNS name of the server.
radius server retransmit
This command configures the global parameter for the RADIUS client that specifies the number of
transmissions of the messages to be made before attempting the fall back server upon unsuccessful
communication with the current RADIUS authenticating server. When the maximum number of
retries are exhausted for the RADIUS accounting server and no response is received, the client
does not communicate with any other server.
Default 4
Format
radius server retransmit <retries>
Mode Global Config
Management Commands
v1.0, November 2010
7-64