NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 461

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no aaa authentication enable
Note: If the default list is not set, only the enable password is checked. This has the same
effect as the following command:
aaa authentication enable default enable
On the console, the enable password is used if it exists. If no password is set, the
process will succeed anyway. This has the same effect as the following command:
aaa authentication enable default enable none
Use this command to remove the authentication method.
Format
no aaa authentication enable {default | list-name} method1
[method2...]
Mode Global Config
aaa authentication dot1x
This command is used to set authentication for dot1x users. The method argument identifies the
list of methods that the authentication algorithm tries, in the given sequence. The additional
methods of authentication are used only if the previous method returns an error, not if there is an
authentication failure. To ensure that the authentication succeeds even if all methods return an
error, specify as the final method in the command line. For example if
none
an authentication method after radius, no authentication is used if the radius server is down.
Format
aaa authentication dot1x default method1 [method2...]
Mode Global Config
method1 [method2...] At least one from the following table:
Keyword
local
none
radius
ias
Management Commands
Description
Uses the local username database for authentication.
Uses no authentication.
Uses the list of all RADIUS servers for authentication.
Uses the internal authentication server users database for authentication.
v1.0, November 2010
is specified as
none
7-45