NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 28

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
nvram:startup-config (in Privileged EXEC) command before performing the stack move.
A stack move causes all routes and layer 2 addresses to be lost. This command is executed on the
Primary Management Unit. The system prompts you to confirm the management move.
Format
movemanagement <fromunit> <tounit>
Mode Stack Global Config
slot
This command configures a slot in the system. The <unit/slot> is the slot identifier of the
slot. The <cardindex> is the index into the database of the supported card types, indicating the
type of the card being preconfigured in the specified slot. The card index is a 32-bit integer. If a
card is currently present in the slot that is unconfigured, the configured information will be deleted
and the slot will be re-configured with default information for the card.
Format
slot <unit/slot> <cardindex>
Mode Global Config
Note: Card index can be obtained by executing show supported cardtype command in
User EXEC mode.
no slot
This command removes configured information from an existing slot in the system.
Format
no slot <unit/slot> <cardindex>
Mode Global Config
Note: Card index can be obtained by executing show supported cardtype command in
User EXEC mode.
Stacking Commands
v1.0, November 2010
2-4